PX501 Control Computer

PX-501 users: Before starting this update procedure, make sure your control computer is connected to a power source and connected to the internet. The procedure is as follows:

1. Backup your settings.
2. Check your registration status.
3. Update SD Drain® Tile.
4. Verify update.
5. Load your saved settings.
6. Verify saved settings.

Detailed instructions below.

Start SD Drain® Tile, start a new project, and proceed to the working screen.

Tap the settings button on the lower right-hand corner of the screen.

The settings you are saving can be viewed by tapping on the Program button and selecting the Profile or Machine pop-out.

To back up your settings, tap the top right Project button and select the Save/Load Settings pop-out.

1. Name the slot by tapping in the window.
2. Press the corresponding Save Slot button.
3. Press Save Settings on the bottom of the page.

Tap the Program button and then select the Support pop-out. 

Check that your Registration Status. If registered, proceed; if expired, contact your dealer.

Select “Check for Updates”

Tap Yes. 

After the update, SD Drain® Tile will close and you will be brought to the desktop.

Start SD Drain® Tile, start a new project, and proceed to the working screen.

Tap the settings button on the lower right-hand corner of the screen.

Tap the Program button and then select the Support pop-out. 

Click on the Project button and select the Save/Load setting pop-out.

2. Press the Load Settings button at the bottom of the page.

Confirm the load.

Press OK after settings have successfully loaded.

You can verify the saved settings by tapping on the Program button and selecting the Profile pop-out. 

Review the settings. Remember to click the down arrow to view more profile settings. 

You can verify more of the saved settings by tapping on the Program button and selecting the Machine pop-out.

Press the Min/Close button and close out of the program.